How to install a card B100P on Elastix 2.0.3 ?

If you want to use B100P with dahdi, you should patch dahdi and asterisk, then recompile them like this:
http://wiki.openvox.cn/index.php/OpenVox_B100P_User_Manual_for_dahdi

Doesn't Elastix recognize B100P...I'm using B400P with dahdi and Elastix 2 with no problem...

Hi,
Problem has been solved.

The method is:

Elastix-2.0.3 is using zaphfc as its driver, for the outbound calls, it works perfectly and no need to modify any files. With regard to the incoming calls, there is a bug of Elastix-2.x. But it's solved. You need to edit some files.
1 >edit the parameter signaling like this:
signaling = bri_cpe_ptmp
2 > give 777 permission to file dialparties,agi in directory /var/lib/asterisk/agi-bin. Save and exit.


Hope this can help you.

Original posted by Joe.Yung at 2011-3-21 03:21

...With regard to the incoming calls, there is a bug of Elastix-2.x. But it's solved. You need to edit some files.
1 >edit the parameter signaling like this:
signaling = bri_cpe_ptmp ...

It's not a bug, it is an ISDN mode that you need to configure according to settings by your telco...it can be PTP or PTMP

Original posted by vmiro at 2011-3-19 05:32

Doesn't Elastix recognize B100P...I'm using B400P with dahdi and Elastix 2 with no problem...

Can you please help us. we are using Elastix 2.0.3 and have a B400P. So far we had no luck in configuring can you please help if you did something else than just installing?
We made a fresh installation and in hardware we get red alarms from the card "Span # 1: B4/0/1 "B4XXP (PCI) Card 0 Span 1" AMI/CCS RED". We also tried to install the mISDN driver but we had no luck.... it show "Found no card. Please be sure to load card drivers."
When we do listpci it looks ok but so far the card is not working.
In need of assistance... Please Help!!!!!!

Earlier I used mISDN driver, but with Elastix I'm using default DAHDI driver with B400P...
After installing Elastix, all I did is go to Hardware Detection - Detect New Hardware and car is configured.

As far as I can see, your card is recognized by Elastix..in my experience .aprox. 90% of problems with ISDN is related to hardware or telco...
Try changing cable connecting B400P and ISDN equipment (I'm using UTP Cat5e cable), change NTU (ISDN Network Termination Unit) it can cause trouble...check your ISDN line with telco...
If ISDN line is configured in PTP mode, L2 is always UP, but if it's in PTMP mode telco shuts it down but after first call it goes UP...this configuration corresponds to my telco configuration, maybe it's different in your country with you telco.

mIRO